EX-ZQ 900-02-3D | Ланфор

Бренды по алфавиту:

Eng Рус

Производитель: Schmersal GmbH

Артикул: Л-0044521

Работаем с юридическими лицами, бюджетными организациями, ИП

По вопросам приобретения товара пишите на zakaz@lanfor.ru

Оплата по безналичному расчету согласно выставленному счету

Самовывоз - бесплатно, от 300руб. до пункта выдачи в Вашем городе, доставка от 500руб. "до двери"

Explosion protection: regulations	EN 60079-31 IEC 60079-0
Explosion protection zones	22
Explosion protection category	3D
Explosion protection designation	D II 3D Ex tc IIIC T100°C Dc
Manufacturer declaration	ATEX Zone 22

Standards	IEC/EN 60947-5-1 EN ISO 13850 IEC/EN 60947-5-5
Enclosure material	Zinc die-cast
Enclosure coating material	painted
Material of the contacts, electrical	Silver
Material of the cover	Steel
Length of the wire, maximum	75 m
Gross weight	1,650 g

Number of auxiliary contacts	0
Number of safety contacts	2

Standards	EN ISO 13849-1
Mission Time	20 Year(s)

B10d Normally-closed contact (NC)	100,000 Operations

Terminal Connector	Screw connection
Cable cross-section of the cable glands, minimum	7 mm
Cable cross-section of the cable glands, maximum	12 mm
Cable section, minimum	0.75 mm²
Cable section, maximum	2.5 mm²
Note (Cable section)	All indications about the cable section are including the conductor ferrules.

Degree of protection	IP67 to EN 60529
Ambient temperature, minimum	-20 °C
Ambient temperature, maximum	+55 °C

Rated insulation voltage U_i	500 V
Rated impulse withstand voltage U_imp	6 kV

Included in delivery	Including Ex-certified screwed cable gland and screw plug

Note (General)	For lengths of over 10 m, intermediate wire supports must be installed every 3 to 5 m. Recommended cable lengths for pull-wire Emergency-Stop switches in relation to the range of ambient temperature. As the thimbles are subject to deformation in case of wire pull, the wire should be pulled several times after fitting. After that, the wire must be re-tensioned using the eyebolt or the tensioner.